Can you remove a pool deck without damaging the pool shell?

Yes, with saw-cut boundaries and controlled breaking. We check the edge conditions and plumbing first.

What about post-tension cables?

Slabs with post-tension cables should never be cut blindly. We scan or review plans first and plan the release with the engineer.

Does the concrete get recycled?

Clean concrete is commonly recycled where facilities accept it. Contamination, rebar and distance to a facility affect what is practical.

Is a permit needed for flatwork removal?

Often not for small flatwork, but it depends on the scope and location. Confirm with City of Mesa Development Services.

Concrete RemovalMesa, AZ

Saw-cutting, breaking and hauling of slabs, driveways, pool decks, footings and block walls on residential and commercial lots.

Get Your Free Quote (714) 333-0178

Concrete removal covers everything from a backyard pad to a warehouse floor. The quality of the result depends on the cuts: clean saw lines keep the edge you are keeping intact, and a defined break pattern keeps vibration away from adjoining slabs, walls and pipes.

Valley soils add a twist. Caliche, a cemented layer in desert soil, can sit close under slabs and footings and makes subgrade work harder than the concrete itself, so we plan for it when the new work needs excavation, footings or drainage.

Scope & Specifications

Common jobs: Driveways, patios, pool decks, garage slabs, sidewalks, curbs, equipment pads, block walls and warehouse floor sections
Cutting: Wet saw-cut at joints and boundaries to a defined depth
Breaking: Hydraulic breaker or plate-break with the slab lifted in pieces where possible
Reinforcement: Wire mesh and rebar are cut free and recycled with the concrete or sorted as scrap
Subgrade: Left rough or re-graded; caliche and compaction conditions noted for the next trade
Dust and slurry: Water control during cutting; slurry contained and kept out of streets and storm drains

Equipment We Use

Walk-behind and flat saws with water supply

Cut control joints and borders with minimal dust and a clean edge

Skid steers with hydraulic breakers

Break slabs in tight yards and enclosed spaces

Excavators with thumbs and breakers

Handle thick footings, retaining walls and larger commercial slabs

Core drills and ground-penetrating radar scans

Locate post-tension cables, conduit and rebar before cutting where the slab type requires it

Roll-off bins and tri-axle trucks

Haul clean concrete to a recycling facility instead of disposal when practical

How the Work Is Sequenced

Identify the slab type
Plain, reinforced or post-tensioned slabs are handled differently; we check plans or scan before any cut.
Locate underground utilities
Arizona 811 marks public lines, and we scan for private irrigation, conduit and gas before breaking.
Cut the boundary
A wet saw defines the removal area and protects the concrete that stays.
Break and lift
Sections are broken in a planned pattern and loaded directly, so the area stays accessible.
Haul and prepare for the next trade
Debris is hauled for recycling and the subgrade is left graded or flagged for follow-up work.

Safety & Compliance

Rules, thresholds and fees change. Use these as a checklist of what to confirm, and rely on the issuing agency for current requirements.

OSHA 29 CFR 1926.1153 (Respirable crystalline silica)

Concrete cutting and breaking creates silica dust; wet methods and, where needed, respiratory protection apply.

OSHA 29 CFR 1926 Subpart T (Demolition)

Covers the safe removal of structural concrete, including walls and elevated slabs.

Arizona 811 (Arizona Blue Stake)

Contact before excavation; hand-dig near marked lines under Arizona's underground facilities rules.

Maricopa County Rule 310

Dust-generating work in the county is regulated; confirm with MCAQD whether a permit or plan applies to the area disturbed.

Stormwater (ADEQ AZPDES and local rules)

Larger disturbed areas may need construction stormwater coverage, and slurry should never reach storm drains.

Mesa Considerations

Local note 1

Block perimeter walls and stucco-covered masonry are widespread in Mesa neighborhoods, and breaking them requires attention to adjoining property lines and shared walls.

Local note 2

SRP canal and irrigation easements cross parts of Mesa; confirm any work near them with the easement owner before cutting or digging.

Local note 3

In July and August, concrete is best broken and hauled in the early morning; monsoon storms can also wash fines into streets, so wetting and sweeping are part of the job.

Concrete Removal FAQs

Can you remove a pool deck without damaging the pool shell?: Yes, with saw-cut boundaries and controlled breaking. We check the edge conditions and plumbing first.
What about post-tension cables?: Slabs with post-tension cables should never be cut blindly. We scan or review plans first and plan the release with the engineer.
Does the concrete get recycled?: Clean concrete is commonly recycled where facilities accept it. Contamination, rebar and distance to a facility affect what is practical.
Is a permit needed for flatwork removal?: Often not for small flatwork, but it depends on the scope and location. Confirm with City of Mesa Development Services.

Serving Downtown Mesa demolition, Fiesta District demolition, Dobson Ranch demolition, Mesa Gateway demolition, Red Mountain demolition.

Contact Mesa Demolition Co about concrete removal

Planning concrete removal?

Tell us about the property and scope and we will walk the site and send a written quote.